Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
userdoc:board_jetway_jbc373f38w [2016/04/11 12:27]
abelbeck
userdoc:board_jetway_jbc373f38w [2019/07/24 22:43] (current)
abelbeck
Line 2: Line 2:
  
 !!Note: Requires AstLinux 1.x!! !!Note: Requires AstLinux 1.x!!
 +
 +!!Note:!! **Not Recommended!** ​ This appliance has been failing (multiple reports) after 3-5 years of use, presumably heat related.
  
 This barebone appliance is also known by the Jetway Part No: HBJC373F38 / HBJC373F38W This barebone appliance is also known by the Jetway Part No: HBJC373F38 / HBJC373F38W
Line 9: Line 11:
 **AstLinux Board Type:** **AstLinux Board Type:**
  
-  * "​genx86_64"​ (VGA video console+  * "​genx86_64"​ (Video Console: ​VGA) 
-  * "​genx86_64-serial"​ (19200 baud serial console)+  * "​genx86_64-serial"​ (Serial Console: ''​19200'' ​baud for AstLinux 1.2.10 and earlier, ''​115200''​ baud for AstLinux 1.3.0 and later)
  
 **Complete System Recommended Options:** **Complete System Recommended Options:**
Line 27: Line 29:
 **Total System Power:​** ​ 15 Watts when idle. **Total System Power:​** ​ 15 Watts when idle.
  
-**Performance:​**  ​48.5 secs. (Maximum OpenVPN: 66 Mbps)+**Performance:​**  ​~50 secs. (Single-core test, lower is better)
  
-  ​openvpn --genkey --secret /​tmp/​secret +  time ( echo "​scale=3456;​ 4*a(1)"​ | bc -l )
-  ​time openvpn --test-crypto --secret /tmp/secret --verb 0 --tun-mtu 20000 --cipher aes-256-cbc+
  
 **Configuration:​** **Configuration:​**
Line 90: Line 91:
 If the board type of "​genx86_64-serial"​ is used, you can change the serial console from the default, rear COM port to the front panel COM port.  From the CLI issue the following command: If the board type of "​genx86_64-serial"​ is used, you can change the serial console from the default, rear COM port to the front panel COM port.  From the CLI issue the following command:
  
-  setconsole-speed-tty ​19200 ttyS1+  setconsole-speed-tty ​115200 ​ttyS1
  
 Revert back to the default rear COM port with the command: Revert back to the default rear COM port with the command: